Tape Operation/Recording; Tape Playback; Rewinding / Fast Forwarding; General Information On Recording - Philips MCD510/25 User Manual

ECO POWER
STANDBY - ON
iR
ALBUM / PRESET
TIMER SET
SOURCE

Tape playback

1
Select TAPE source.
➜
The display shows "TAPE
2
Press OPEN/CLOSE ç to open the tape
door.
3
Insert a recorded tape and close the tape door.
●
Load the tape with the open side downward
and the full spool to the left.
4
Press É Å on the system to start playback.
To stop playback
●
Press Ç (STOP9 on the remote).
To reset the tape counter display
●
In stop mode, press Ç (STOP9 on the
remote) once.

Rewinding / Fast forwarding

1
Stop playback, press TUNING S/T.
➜
The tape will stop automatically at the end of
rewinding or fast forwarding.
➜
During fast winding, you can monitor the tape
message with the tape counter.
2
Press Ç (STOP9 on the remote) to stop
rewinding or fast forwarding.
RECORD
M C D 5 1 0 M I C R O S Y S T E M
TUNING
PROGRAM DSC DBB
INCREDIBLE
SURROUND
TAPE" briefly.
TAPE TAPE TAPE

Tape Operation/Recording

BAND CLOCK SET
DISPLAY RDS
VOLUME
OPEN/
CLOSE
General information on
recording
●
For recording, use only NORMAL (IEC type I)
tapes on which the tabs have not yet been
broken. This deck is not suitable for recording on
METAL (IEC IV) type tapes.
●
The best recording level is set automatically.
Altering the VOLUME, INCREDIBLE
SURROUND or DBB will not affect the
recording in progress.
●
At the very beginning and end of the tape, no
recording will take place during the 7 seconds
when the leader tape passes the recorder heads.
●
To protect a tape from accidental erasure, have
the tape in front of you and break out the left
tab. Recording on this side is no longer possible.
If, however, you wish to record over this side
again, cover the tabs with a piece of adhesive
tape.
IMPORTANT!
Recording is permissible if copyright or
other rights of third parties are not
infringed upon.
/PROG /PROG
IS DSC
33