General Instrument XRC 200 User Manual

XRC 200
UNIVERSAL
REMOTE
CONTROL
(Made in the Philippines)
GETTING STARTED
Congratulations! Your XRC
200 universal remote control
brings new convenience to
television viewing. By
pressing a few keys, you can
see what is on TV, select a
program to watch, set up to
record programs on your
VCR, and much more.
The XRC 200 universal
remote control has been
designed to control most TV
sets and VCRs on the market
today as well as your cable
device, eliminating the
frustration of having to use
several remote controls.
Before you start to program
your remote control, please
read the following important
instructions.
The XRC 200 enables you to:
•
Control multiple devices
such as a
device, TV, and VCR.
•
Control an auxiliary
device such as a second
TV or VCR or a digital
audio tuner.
•
Control the volume
through your TV while in
Cable mode. (Refer to
Programming Volume
Control later
brochure.)
•
Control services such as
Digital Music Express
TM and Music
.
SM
REPLACING THE
BATTERIES
Use two fresh 1.5 volt, AA
batteries. To install or
replace the batteries:
1. Slide the
battery
door open
on the
back of
the remote
control.
2. Remove
the old
batteries,
and insert
the new
ones as
indicated.
3. Slide the
battery
door
closed
until it
snaps into
place.
4. Point the remote control
at your cable device,
cable press CABLE, and then
press POWER. The
CABLE key lights.
If the key does not light,
check the battery orientation,
or replace the batteries as
needed.
If you replace the batteries
within a few hours after
removing the old batteries,
in this
you will not need to
reprogram the remote
control.
USING THE KEYBOARD
Choice
Use the mode keys to switch
control to a device. The four mode
keys (AUX, VCR, CABLE, or TV)
light to indicate which device is
being controlled.