Getting Started; Step 1: Using The Remote Control; Step 2: Setting Up The Tv - Philips MCD106 User Manual

Step 1: Using the Remote
Control
1. Open the battery compartment.
2. Insert two batteries type AAA, following the
indications (+/-) inside the compartment.
3. Close the cover.
CAUTION!
– Remove batteries if they are
exhausted or if the remote is not to be
used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical
substances, so they should be disposed of
properly.
Using the Remote Control to operate
the Player
1. Aim the Remote Control
directly at the remote sensor
(IR) on the front panel.
2. Do not put any objects
between the remote control
and the DVD player while
operating the DVD player.

Getting Started

Step 2: Setting up the TV

IMPORTANT!
Make sure you have completed all the
necessary connections. (See "Connecting
TV").
1. Press STANDBY-ON B on the DVD player
to turn it on.
2. Turn on the TV and set to the correct video-in
channel. You should see the blue Philips DVD
background screen on the TV.
➜ Usually these channels are between the
lowest and highest channels and may be called
FRONT, A/V IN, or VIDEO. See your TV manual
for more details.
➜ Or, you may go to channel 1 on your TV,
then press the Channel up button repeatedly
until you see the Video In channel.
➜ Or, set the TV to channel 3 or 4 if you are
using an RF modulator.
3. If you are using external equipment, (e.g. audio
system), turn it on and select the appropriate
input source for the DVD player output. Refer to
the equipment user's manual for detail.
9