Preparations; Inserting Batteries Into The Remote Control; Switching On The System - Philips LX3700D Owner's Manual

Inserting batteries into the
remote control
1
Open the battery compartment.
2
Place the batteries in the
compartment with the correct
polarity as indicated by "+" and
"-" symbols.
3
Close the cover.
CAUTION!
– Remove batteries if they are exhausted or will
not be used for a long time.
– Do not use old and new or different types of
batteries in combination.
– Batteries contain chemical substances, so they
should be disposed off properly.

Switching on the system

IMPORTANT!
Make sure you have completed all the necessary
connections. (See page 10 "Connecting TV")
1
Press STANDBY ON to switch on the system.
2
Press SOURCE until "DISC" appears on the display panel
(or press DISC on the remote).
3
Turn on the TV and set to the correct video-in channel. You
should see the blue Philips DVD background screen on the
TV.
Usually this channel is between the lowest and highest
channels and may be called FRONT, A/V IN, or VIDEO. See
your TV manual for more details.
Or, you may go to channel 1 on your TV, then press the
Channel down button repeatedly until you see the Video In
channel.
Or, the TV remote control may have a button or switch
that chooses different video modes.
Or, set the TV to channel 3 or 4 if you are using an RF
modulator.
– If you do not get a proper picture or sound,
please refer to "System Setup (DVD)" in order to
change the pre-settings as necessary to
accommodate your TV system or change to your
preferred settings.

Preparations

P 17
REPARATIONS