Table of Contents
Advertisement
STEP 3
Rotate the earpiece
toward the back of your
head as you push the
earpiece in.
STEP 5
Once inserted, don't be afraid
to push on the canal portion of
the earpiece to make sure it is
all the way in. You may find it
helpful to pull back on your ear
while pushing the earpiece in.
EARPHONE REMOVAL
Never pull on the cable to remove your earphones! Instead,
reach behind the earpiece at the bowl of the ear and twist the
earpiece toward the front as you remove it. Simple!
AUDIO SEAL TEST
As with all isolating earphones, your 3D earpieces must be fully
inserted to create a deep, tight seal. A poor seal will result in a
loss of bass response and lack of isolation. To confi rm that you
have achieved a full seal, use our downloadable audio seal test
at www.sensaphonics.com/test.
STEP 4
Make sure the top portion of the
earpiece is tucked in. If not, you
will not have a good seal and will
lose isolation and base response.
See Step 5 photo for correct placement.
STEP 6
Bend the "memory wire"
cable tightly around the top
of your ear. Adjust the length
of the cable ends by moving
the zipper (split adjuster) up
and down where they meet.
7
Advertisement
Table of Contents
