Getting Started; Moistening The Electrodes - Tanita SR-901 User Manual

Getting started

Insert the batteries
1. Open the battery cover by loosening the
2 screws with the supplied screwdriver.
2. Put the + side of the batteries as
indicated, close the battery cover and
replace the screws.
Note: Do not use other batteries than the specified batteries
(CR2032)
Replace the batteries
When the battery power runs out, "Lo" will
be displayed. Replace with 2 new batteries
(two CR2032).
Take a thin rod, needle,
as shown, lift the
batteries and take
them out.
Replace the batteries
and close the battery cover.
Note: Only replace the batteries when the instrument is dry and
with dry hands
Always replace the two batteries at the same
time
• Keep out of reach of children and pets.
• Included batteries can be less than
100% full
• You can deposit used or discharged
batteries at public collecting points
Moistening
the electrodes
• Insert water in the spray
bottle
• Moisten the 4 electrodes
with water from the
spray bottle
Note: Only use water to moisten the electrodes
• Always moisten the 4 electrodes
before each measurement
• After measurement, wipe the
instrument dry with a dry cloth
and store the spray bottle for
next usage.
When the display shows "Dry";
you will not be able to measure
correctly.
Possible issues:
• the skin is keratinized
• there is too much dark hair
at the measurement area
• the skin is dry
05