Operating The Energizer; Using The Nemtek Tag - Nemtek AGRI Solar Instruction Manual

AGRI Solar

Operating the Energizer

Present the Nemtek Tag
(Supplied with the energizer)
Operating the energizer is straightforward. Once the energizer is turned on,
it will pulse the fence once per 1.5 seconds. The pulse rate & power
indicator (ENERGIZER) should flash once with each fence pulse.
The (ENERGIZER) indicator flashes green to indicate high power mode or
red to indicate low power mode. The power status indicator (BATTERY)
glows green if the battery is above 50% capacity, glows yellow when the
battery capacity falls below 50% and glows red when the battery capacity is
below 5%.
The energizer disconnects the battery when the battery becomes
discharged, and will reconnect the battery automatically when solar power is
available again. Solar regulator status (SOLAR) is green when the battery is
charging, unlit when the battery is discharging and red when the battery is
not connected.
If the energizer is not actively pulsing, it will automatically disconnect the
battery after a short period of time and can be stored away in this state. The
battery will automatically get reconnected when solar power is available or
the Nemtek tag is presented to the energizer.
10