Baby Trend HC57B Instruction Manual page 3

WARNING
WARNING:
Failure to follow these warnings and the
instructions could result in serious injury or death.
WARNING:
Prevent serious injury or death from falls
or sliding out. Always secure child in the restraint. NEVER
leave child unattended.
WARNING:
The child should be secured in the
high chair at all times by the 5-point restraining system,
either in the reclining, semi-reclining or upright position.
The tray is not designed to hold the child in the chair.
It is recommended that the high chair be used in the
upright position only by children capable of sitting upright
unassisted. See page 10 for instructions on proper use of
restraint system.
• approved SNAP TECH products can be used on the frame.
ONLY
TM
• Other accessory items may change the balance of the high chair and cause hazardous
unstable conditions, use approved Baby Trend toys only.
• Be certain the high chair is fully erect and latched in the open position before allowing the
child near the high chair.
• Use of the high chair with a child weighing more than 40 pounds will cause excessive wear
and stress on high chair.
• NEVER allow your high chair to be used as a toy.
• use this product if there are any loose or missing fasteners, loose joints, broken
NEVER
parts, or torn mesh/fabric. Check before assembly and periodically during use. Contact
Baby Trend Customer Service at 1-800-328-7363 for replacement parts, repair or
instructions. substitute parts.
NEVER
3
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
IMPORTANT!
To ensure safe operation of your product, please follow
these instructions carefully. Please keep these instructions for future reference.
IMPORTANT!
Before assembly and each use, inspect this product
for damaged hardware, loose joints, missing parts or sharp edges. NEVER
use if any parts are missing or broken.
IMPORTANT!
Adult assembly is required.
IMPORTANT!
Always check that the high chair is locked in the open
position before using.
ATTENTION:
Carefully remove parts from box. Check that
you have all the parts for this model before
assembling the high chair. NOTE: Certain
High Chair models are packaged with the
High Chair Seat Fabric and Body Insert
already attached to the Seat Back.
TO ASSEMBLE FRAME
• Take either the left or right Upper Frame
1)
Assemblies, press and hold the button
and extend the frame then release the
button (Fig 1a).
• Insert the front tube of the right and left
side Upper Frame Assemblies into the
Height Adjuster (Fig. 1b). The front tube
is easily distinguished from the rear
tube by the array of holes located on the
backside of the front tube.
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Button
Fig. 1a
Fig. 1b
4