Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for MAKSIWA RBB.1000
Summary of Contents for MAKSIWA RBB.1000
- Page 1 RBB.1000 Edge Trimmer Machine ____________________________________________________________________ INSTRUCTION MANUAL ____________________________________________________________________ ATTENTION: READ THIS MANUAL BEFORE USING YOUR MACHINE.
- Page 2 Keep all tools in order. Keep tools sharp and clean INSTRUCTION MANUAL better safer performance. Follow Important information you should know: instructions for lubricating and changing accessories. The images in this manual are illustrative and are Unplug the machine before servicing or changing meant to demonstrate the correct operation of your accessories such as scissors, cutters etc.
- Page 3 All Make sure that the knobs and screws are properly equipment MAKSIWA are tested at the factory. If this machine does not work, check the electricity supply. tightened and safe before starting any operation.
-
Page 4: Unpacking And Assembly
UNPACKING AND ASSEMBLY UNPACKING Due to modern mass production techniques, it is unlikely that Edge Trimmer RBB.1000 MAKSIWA is faulty or have parts missing. If you find anything wrong, do not use the machine until the parts are replaced or the fault 2. - Page 5 3. Assembly of Extension Table Enter the two Adjustable Guides (2) into the holes of the main structure leaving 2inches ends out and screw the knobs (3) by pressing them on the guides: One of the supports of the Piston (6) is already mounted on the Swinging Support (4) and the other are the group of nut and hexagon socket screw (Allen) M6 (5) to be mounted on the upper end of the scraper set, as shown...
- Page 6 ¼’’(9): SETTINGS The following shown adjustments must be made before using your Edge Trimmer RBB.1000 for the first time or when some kind of change is made as thick tape or thickness of the wood.
- Page 7 1. CUTTER ALIGNMENT 2. ADJUSTING THE SPRING OF SCRAPER BLOCK The horizontal alignment of the cutter was did at the The spring tension of the scraper block copier is set at factory, however, for possible adjustments, using the key the factory, but for any adjustments using the key 13 (8). 13 (8), loosen the screw of the eccentric washer and Must loosen the lower nut shown in the figure below and turn it until the cutter shaft center is aligned to the line of...
- Page 8 Loosen the handle knob of the scraper block and lift it The vertical positioning and inclination adjustment is then introducing model of the workpiece already with the realized by the two screws positioned at the side of the edge tape applied and pre-trimmed by router. scraper block, also using the Phillips screwdriver (7): Get down again the scraper resting it on the surface of the workpiece.
-
Page 9: Extension Table
Above all, your safety must come first. Down again the scraper, resting it on the surface of the To get a good result at the finishing with RBB.1000 is piece. With the left thumb exerting a light pressure on it, important that the preparation of the workpiece and the fixing it again the knob. -
Page 10: Maintenance
OFF and unplugged from the outlet to prevent accidental discharges. Periodic maintenance on your Edge Trimmer RBB.1000 MAKSIWA will ensure optimum performance. Make it a habit to inspect your equipment every time you use it. -
Page 11: Maintenance Schedule
(including inspection and replacement) for components replaced by manufacturing defect will be technical assistance recommended by MAKSIWA, provided for free as long as duly proved by Maksiwa always use genuine spare parts and accessories, Service. reassembling to its original Edge Trimmer the same 3.
Need help?
Do you have a question about the RBB.1000 and is the answer not in the manual?
Questions and answers