Tv Control & Operation; Inserting The Batteries Into The Remote; Connect Power; Antenna Connection - Philips 6031 SERIES User Manual

TV Control & Operation
The joystick allows you to control the Volume / Programme /
Source and Standby-On functions of the TV.
Note:
The position of the joystick may differ depending on the model.
To change volume: Increase the volume by pushing the joystick
right. Decrease the volume by pushing the joystick left.
To change channel: Scroll through the stored channels by
pushing the joystick up or down.
To change source: Press the centre of the joystick in, the
sources list will appear on the screen. Scroll through the
available sources by pushing the joystick up or down.
To turn the TV off: Press the centre of the joystick in and hold
it down for a few seconds, the TV will turn into standby mode.
To turn on the TV: Press the centre of the joystick in, the TV
will turn on.
Note: Main menu OSD cannot be displayed via control button.
Operation with the Remote Control
Press the Menu button on your remote control to display main
menu screen. Use the directional buttons to select a menu tab
and press OK to enter. Use the directional buttons again to
select or set an item. Press Return/Back or Menu button to
quit a menu screen.
Input Selection
Once you have connected external systems to your TV, you can
switch to different input sources. Press the Source button on
your remote control consecutively to select the different sources.
Changing Channels and Volume
You can change the channel and adjust the volume by using
the Volume +/- and Programme +/- buttons on the remote.

Inserting the Batteries into the Remote

Remove the back cover to reveal the battery compartment.
Insert two size AAA batteries. Make sure the (+) and (-) signs
match (observe correct polarity). Do not mix old and new
batteries. Replace only with same or equivalent type. Place
the cover back on.

Connect Power

IMPORTANT: The TV set is designed to operate on 220-240V
AC, 50 Hz socket. After unpacking, allow the TV set to reach
the ambient room temperature before you connect the set to
the mains. Plug the power cable to the mains socket outlet.
P+
V+
V-
P-
English - 4 -

Antenna Connection

Connect the aerial or cable TV plug to the AERIAL INPUT (ANT-
TV) socket or satellite plug to the SATELLITE INPUT (ANT SAT)
socket located on the rear bottom side of the TV.
Rear bottom side of the TV
satellite

Notification

TRADEMARK ACKNOWLEDGMENT
The terms HDMI and High-Definition Multimedia Interface, and
the HDMI Logo are trademarks or registered trademarks of
HDMI Licensing LLC in the United States and other countries.
Manufactured under license from Dolby Laboratories. Dolby
and the double-D symbol are trademarks of Dolby Laboratories.
YouTube and the YouTube logo are trademarks of Google Inc.
Information for Users on Disposal of Old Equipment and
Batteries
[European Union only]
Equipment bearing these symbols should not be disposed as
general household waste.
You should look for appropriate recycling facilities and systems
for the disposal of these products.
Notice: The sign Pb below the symbol for batteries indicates that this
battery contains lead.
Products
aerial
or
cable
Battery