Related Manuals for HORITA BSG-50
Summary of Contents for HORITA BSG-50
-
Page 1: User Manual
HORITA BSG-50 Blackburst, Sync, Audio Tone Generator USER MANUAL For Models BSG-50, RM-50/BSG, SR-50/BSG Doc. 070450 Rev. F (C) Copyright 2014 P.O. Box 3993, Mission Viejo, CA 92690 (949) 489-0240 www.horita.com... - Page 2 No part of this document may be copied or reproduced in any form or by any means without prior written consent of HORITA CO., INC., P.O. Box 3993, Mission Viejo, CA 92690. HORITA CO. makes no warranties with respect to this documentation and disclaims any warranties of merchantability or fitness for a particular purpose.
-
Page 3: Table Of Contents
TABLE OF CONTENTS GENERAL CHAPTER 1 FEATURES CHAPTER 2 CONNECTING AND OPERATING THE BSG-50 CHAPTER 3 Connecting Power Operating from Battery Power Connecting the Output Signals Selecting the Output Signals Sync Signal Selection Subcarrier Output Selection Operating the BSG-50 MAINTENANCE... -
Page 5: Connecting And Operating The Bsg-50
BNC connectors and is set up to output six blackburst and two composite sync signals. A special feature of the BSG-50 is that each of the four sync signals available for output can be individually set to be composite sync, composite blanking, horizontal drive, or vertical drive. Additionally, one of the sync signals can be set to burst flag. -
Page 6: Operating From Battery Power
1. Remove power from the BSG-50. 2. The bottom of the BSG-50 is a cover which slides out towards the front. There are two screws which attach the front panel of the BSG-50 to the case. Turn the BSG-50 upside down and remove the two screws from the BSG-50 front panel. -
Page 7: Sync Signal Selection
It may be necessary to slightly readjust burst amplitude and SCH when sucarrier is selected. 3.7 Operating the BSG-50 To operate the BSG-50 simply connect the desired output signals and power it up. A red LED above the power switch comes on when the BSG-50 is powered up. -
Page 9: Maintenance
Check all coaxial cables for opens or shorts. b. If using an AC power adapter different from the one supplied with the BSG-50, make sure it supplies the BSG-50 with at least 9 volts (maximum of 13.5 volts) when the BSG-50 is switched on. -
Page 10: Setup, Sync, And Burst Levels
4. The TV monitor will "lock up" to either the BSG-50 or the off air signal, sometimes switching back and forth between the two. There will be a relatively dark vertical bar going from top to bottom of the screen and it will appear to be stationary or to be moving slightly from left to right or from right to left. -
Page 11: Specifications
SPECIFICATIONS Power Operation 9-to-13.5V DC, 100 milliamperes Connector 3.5 MM mini phone jack AC Adapter 9 volt, 500 milliamperes Blackburst Output Standard RS-170A Amplitude Equivalent to 1 volt p-p video signal with 75 ohm load Setup +7.5 IRE units, adjustable from 0 to +10 IRE units Adjustments Sync amplitude, burst amplitude setup level, subcarrier frequency, SCH.
Need help?
Do you have a question about the BSG-50 and is the answer not in the manual?
Questions and answers