Drucker 614B Operator's Manual

Drucker 614B Operator's Manual

Laboratory centrifuge

Advertisement

Reliability in Laboratory Centrifuges Since 1932
Operator's Manual
Model 614B • Laboratory Centrifuge
Rev. C
P/N 7711001

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 614B and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Drucker 614B

  • Page 1 Reliability in Laboratory Centrifuges Since 1932 Operator’s Manual Model 614B • Laboratory Centrifuge Rev. C P/N 7711001...
  • Page 2: Table Of Contents

    Model Description: The Model 614B is a continuous duty centrifuge designed for the small lab or doctor’s office for the purposes of separating laboratory fluids. The unit is controlled by a mechanical timer settable from 1 to 30 minutes. Samples can be safely viewed through the transparent lid.
  • Page 3: Features

    • Clear lid for safe observation of samples and optical calibration of speed is free from defects in workmanship and parts for 12 months. Specifications: General Specifications for the Model 614B Centrifuge Nominal Speed (125mm holders): 3,150 (± 100) RPM Nominal RCF (125mm holders): 1,200 (± 80) xg Nominal Speed (100mm holders): 3,250 (±...
  • Page 4: Safety

    If any problems are found during the initial setup procedure, refer Available Accessories: to the troubleshooting section on page 8. For further assistance, contact The Drucker Company at 814-692-7661. 1” Tube cushion Plug the centrifuge in to an approved electrical outlet. For electrical safety,...
  • Page 5 10. Remove the samples. 11. The centrifuge is immediately ready for operation. Circuit Breaker: The Model 614B is protected with a 4 Amp circuit breaker located at the rear of the machine mounted to the base. Any electrical short circuit will cause the breaker to cut power to the machine.
  • Page 6: Warranty

    Care and Preventative Maintenance: Tube Holder Configurations: The fixed-angle rotor that came with your Model 614B is capable of spinning test tubes up to 17mm x 125mm. Use the following chart and drawing to determine which tube With proper care and maintenance your centrifuge will provide years of holder and cushion combination should be used with your application.

Table of Contents