Hardware Operations
2.6 SAS IO Module
Reminder
Before you remove or install the SIM node, please follow the steps below:
Step 1:
Make sure the SIM node is not turned on.
Step 2:
Disconnect all necessary cables.
Please make sure the top rear chassis cover is installed when removing or installing
any SIM nodes to prevent the docking board connectors on the interposer board
from damage.
2.6.1 To remove the SIM node
Press the retaining latch.
Slide the SIM node out of the chassis by using the handle.
2.6.2 To install the
Push the SIM node into the chassis until it's completely seated in place.
20
Figure 2-18 Removing the Node
node
SIM
Figure 2-19 Installing the SIM Node