Table of Contents
Advertisement
2.4 3.5" SATA/SAS HDDs
DNS-2670 can support 70 x 3.5" hot-pluggable SATA/SAS HDDs.
Reminder
Before you remove or install the 3.5" SATA/SAS HDDs, please follow the steps below:
Step 1:
Make sure all of the SIM nodes are not turned on and the server is not connected
to AC power.
Step 2:
Remove the chassis cover. To remove the chassis cover, see "0
To remove the chassis cover .
Step3:
Disconnect all necessary cables.
Take note of the drive tray orientation before sliding it out.
The tray will not fit back into the bay if inserted incorrectly.
2.4.1 To remove a Disk
Push the release button.
Pull the lever open.
Slide the Disk assembly out of the Disk bay.
Loosen the four screws that secure the Disk.
Lift the Disk out of the Disk tray.
Figure 2-10 Removing the Disk Assembly
Hardware Operations
15
Advertisement
Table of Contents
