Download Print this page

Advertisement

Quick Links

Product Disposal—
Certain international, national
and/or local laws and/or reg-
ulations may apply regarding the
disposal of this product. For further
detailed information, please
contact the retailer where you
purchased this product or the Morel
Distributor in your
country.
Morel's distributors can be found
at the website:
morelhi .com
SPECIFICATIONS
Construction
MDF coated paint piano finish
10.6"x11.6"x10.6"
Dimensions
(27x29.5x27 cm)
One 8" subwoofer with 2" voice coil and
Drive unit
rear-vented magnet motor
Frequency response
35-160Hz
Morel operates a product design improvement policy consequently specifications are subject to alterations without prior notice
IMPORTANT SAFETY INSTRUCTIONS
READ BEFORE OPERATING EQUIPMENT
1. Read these instructions.
2. Keep these instructions.
3. Read all warnings.
4. Follow all instructions.
5. Do not use the subwoofer near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves,
or other apparatus (including ampli ers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has
two blades with one wider than the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong are provided for your safety. If the provided
plug does not t into your outlet, consult an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories speci ed by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table speci ed by the
manufacturer, or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when unused for long periods
of time.
14. Refer all servicing to quali ed service personnel. Servicing is required when the apparatus
has been damaged in any way, such as power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the apparatus has been exposed
to rain or moisture, does not operate normally, or has been dropped.
15. WARNING:
To reduce the risk of re or electric shock, this apparatus should not be exposed to
rain, moisture and objects lled with liquids. should not be placed on this apparatus.
16. To completely disconnect this equipment from the mains, disconnect the power supply cord
plug from the receptacle.
17. The main plug of the power supply cord shall remain readily operable.
Amplifier
Input
Voltage
Net weight
80W,class AB, continuous power, all formats compatible
with automatic on/off switch, level, crossover and phase
controls.
Less than 0.5W in standby.
Line-level RCA phono jack / Hi Level In
220-240VAC 50Hz
16.5 lbs (7.5 Kg)

Advertisement

loading
Need help?

Need help?

Do you have a question about the SUB-8X and is the answer not in the manual?

Questions and answers

Summary of Contents for Morel SUB-8X

  • Page 1 One 8” subwoofer with 2” voice coil and Drive unit rear-vented magnet motor Voltage 220-240VAC 50Hz Net weight 16.5 lbs (7.5 Kg) Frequency response 35-160Hz Morel operates a product design improvement policy consequently specifications are subject to alterations without prior notice...
  • Page 2 SUBWOOFR ADJUSTMENTS AC Power Connection And AUTO ON/OFF (AUTO mute circuit) The SUB-8X features auto on/off circuitry , marked “AUTO”, that automatically turns your subwoofer on when it senses a signal. To activate it turn the Auto swith to the ON position. When no signal is present, the circuit turns the subwoofer off after a few minutes.
  • Page 3 STEREO RECEIVER If you select to use the speaker level input , use two-con- ductor 16 gauge or thicker speaker wires. see your Morel dealer for wire recommendations. Strip 1/2’’ (12mm) of insulation from each of the two conductors on both ends to expose the bare wire. Twist the exposed wire of each conductor to form two un-frayed strands.
  • Page 4 OPTION 3- Adding an additional subwoofer to the system is possibe by connect- ing an RCA cable to the Line Output (first subwoofer) and Line Input of the second subwoofer. Use either L or R or Y-splitter as in Option 1. SUBWOOFER POSITIONING Full 5.1 surround Fig 1...