Advertisement
Wi USB AudioLink Installation
Windows XP
1.
Connect the Wi USB transmitter to one of
the USB ports on your MAC desktop or
notebook computer.
2.
Windows XP will recognize the Wi USB
AudioLink and automatically install the
universal driver. A balloon will pop up, telling
you the computer has found the Wi USB
AudioLink. When Windows is finished
installing the drivers, a balloon pop up will
say "Your device is installed and ready to use."
3.
To set the Wi USB AudioLink as your default
device for sound playback and recording, or
to change its settings, click the Start button,
click Control Panel and then click Sounds
and Audio Devices. In the Audio tab, select
the Wi USB AudioLink from the drop-down
menu.
4.
To set the audio level, click the Volume
button in the Sound playback section, and set
the Speaker slider to the maximum position.
Use the receiver's volume controls to
control the overall volume output.
5.
To set the gain of the microphone when using
the Wi USB AudioLink with the Wi Audio
Stream receiver, click the Volume button in
the Sound recording section. It will say "Wi
USB AudioLink" in the status bar at the bottom.
Moving the slider will adjust the microphone gain.
5. Proceed to the Pairing section of this guide.
Advertisement
