Sony HT-FS30 Operating Instructions Manual page 40

Sound lags behind the TV image.
• Set the "A/V SYNC" to "OFF" if "A/V
SYNC" is set to "ON."
No sound or only a very low-level sound of the
connected equipment is heard from the
system.
• The low-level sound may be subtle,
depending on the program or disc. Adjust the
subwoofer level (page 37).
• Press 2 + and check the volume level.
• Press or 2 + to cancel the muting
function.
• Check that the input source is correctly
selected.
• Check that all the cables and cords of the
system and the connected equipment are
fully inserted.
• Check the HDMI setting of the connected
equipment.
No sound is output from specific speakers.
• Check that the connectors of the speaker
cord are fully inserted into the jacks.
Sound is interrupted or there is noise.
• Check "Formats supported by this system"
(page 42).
It takes time until the sound is output from the
system after it is turned on.
• In the following cases, it may take time until
sound is output from the system after it is
turned on:
– When any of the equipment connected to
the system via the HDMI connection are
not compatible with the Control for
HDMI function.
– When the Control for HDMI function is
set to off on any of the connected
equipment.
In these cases, use the system after setting
the Control for HDMI function to on all the
connected equipment, or setting the Control
for HDMI function to off on all the
equipment, including the system itself.
40
GB
IMAGE
No image appears on the TV.
• Check that the TV and the system are
connected correctly.
• Check that the TV is selected correctly.
• Press the input buttons to change the input
source.
• Set the TV to the appropriate input mode.
• Check whether HDMI IN and HDMI OUT
are connected in reverse.
• Check that the cords are fully inserted into
the jacks on both the equipment and this
system (pages 15, 17).
No 3D image appears on the TV.
• Depending on the TV or the video
equipment, 3D images may not be
displayed. Check the 3D image formats
supported by the system (page 42).
When the system is in standby mode, there is
no image or sound on the TV.
• Set the "CTRL HDMI" to "ON" if "CTRL
HDMI" is set to "OFF" (page 38).
• When the system is in standby mode, image
and sound are output from the HDMI
equipment selected the last time you turned
off the system. If you want to play a
equipment other than the HDMI equipment
you selected last time, play the equipment
via One-Touch Play, or turn on the system to
select the HDMI equipment you want to
enjoy.
• Make sure "PASS THRU" is set to "ON" in
the AMP menu if you connect equipment not
compatible with "BRAVIA" Sync to the
system (page 38).
The remote control does not
function
• Point the remote control at the remote
control sensor
• Remove any obstacles in the path between
the remote control and the system.
• Replace both batteries in the remote control
with new ones, if they are weak.
• Make sure you select the correct input on the
remote control.
on the system.