ECO Spot LED B90E User Manual

ECO Spot™ LED B90E/B150E/B300E
Exterior User Manual
Thank you for choosing an ECO Spot™ Gobo projector.
Please read this manual before installing or operating this fixture,
follow the safety precautions listed below and observe all warnings.
WARNING! - To prevent damage to the LED, always
connect the driver to the projector FIRST before
powering up the driver.
Package Contents

Projector with Projection Lens

External LED Driver

Test Gobo mounted

Thread ring with silicone seal for the projection lens
Safety Information
•
Place your fixture at a suitable place with good air flow.
•
Keep flammable materials away from the fixture.
•
Minimum distance to flammable material = 1 ft (0.3m).
•
Provide a minimum clearance of 4 in (10cm) around air vents.
•
Do not look directly into the lamp; it can result in eye damage.
•
Always unplug the unit from the power mains before any service is done.
•
Light fixtures should be installed and maintained only by qualified personnel with
experience in lighting equipment and general electrical experience.
Electrical Safety
•
Disconnect the fixture from AC power before handling it.
•
Follow all local building and electrical codes and apply both, overload and
ground-fault protection.
•
Do not use the fixture if the power cable or power plug is in any way damaged,
defective or wet, or if they show signs of overheating.
•
The fixtures have power plugs for testing and for indoor use but exterior
installations usually require hard-wired connections. Follow all related codes.
Copyright © 2015 Globus New Media LLC
ECO Spot LED B90E/B150E/B300E User Manual
Page 1