ECO Spot LEDB90 User Manual

Package Contents

Projector with power cord
•
Test Gobo
•

Safety Information

This product is not for household use, it presents risks of severe injury or death due to fire
•
and burn hazards, electric shock, lamp explosion and falls.
Place your fixture at a suitable place with good air flow.
•
Keep flammable materials away from the fixture.
•
Minimum distance to flammable material = 1 ft (0.3m).
•
Minimum distance to illuminated surface = 3.3 ft (1.0m).
•
Provide a minimum clearance of 4 in (10cm) around air vents.
•
Use only genuine spare parts for part replacement.
•
Do not look directly into the lamp; it can result in eye damage.
•
Don't touch the hot surface during operation, use gloves if necessary.
•
Always unplug the unit from the power mains before any service is done.
•
Allow 20 minutes to cool down before servicing the unit.
•
Replace Lamps only with the same type other lamps may cause damage.
•
Light fixtures should be installed and maintained only by qualified personnel with
•
experience in lighting equipment and general electrical experience.

Electrical Safety

Disconnect the fixture from AC power before handling the fixture.
•
Always ground (earth) the fixture electrically.
•
Use only a power source that complies with local building and electrical codes and has
•
both overload and ground-fault protection.
Do not use the fixture if the power cable or power plug is in any way damaged, defective or
•
wet, or if they show signs of overheating.
Copyright © 2015 Sunhope Inc
TM
ECO Spot
Thank you for choosing our ECO Spot
manual before installing or operating this fixture, follow the safety
precautions listed below and observe all warnings.
dba thegobo.com
LEDB90 / B150 User Manual
TM
Gobo Projector. Please read this
Page 1 of 4