Lighting; Saturation Signal; Cleaning And Maintenance; Cleaning Agents - Siemens LF959RB51 Instruction Manual

Cleaning and maintenance

en

Lighting

The lighting can be switched on and off independently
of the ventilation.
Press the button.
A

Saturation signal

The following will happen when the filters are saturated:
The symbol appears in the display: Clean the
ª
■
metal grease filter
The symbol appears in the display and a signal
'
■
sounds: Replace the activated charcoal filter
See the "CleanAir air recirculation module" printed
supplement or the section entitled~ "Cleaning and
maintenance" on page 8
Resetting the saturation signal
When the fan is switched off, the signal is also switched
off.
The relevant filter(s) should be cleaned now if you have
not already done so.
Switching over the appliance to air recirculation
Switch off the appliance.
1.
Press the and
$ *
2.
the same time until the
release the buttons.
The indicator will go out shortly afterwards. The
'
electronic controller has now been switched over to air
recirculation mode.
Switching over the appliance to air extraction
The default setting is air extraction mode.
Note:
Switch off the appliance.
1.
Press the and
$ *
2.
the same time until the
release the buttons.
The indicator will go out shortly afterwards. The
ª
electronic controller has now been switched over to air
extraction mode.
8
buttons on the control panel at
indicator lights up. Then
'
buttons on the control panel at
ª indicator lights up. Then
2Cleaning and maintenance
:
Warning – Risk of burns!
t e n a n c e C l e a n i n g a n d m a i n
The appliance becomes hot during operation. Allow the
appliance to cool down before cleaning.
:
Warning – Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
:
Warning – Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:
Warning – Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.

Cleaning agents

To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table. Do not use any of the following:
Harsh or abrasive cleaning agents,
■
Cleaning agents with a high alcohol content,
■
Hard scouring pads or cleaning sponges,
■
High-pressure cleaners or steam cleaners.
■
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the
cleaning agents.
Area Cleaning agent
Stainless steel Hot soapy water:
Clean with a dish cloth and then dry with a
soft cloth.
Clean stainless steel surfaces in the grind
direction only.
Special stainless steel cleaning products are
available from our after-sales service or from
specialist retailers. Apply a very thin layer of
the cleaning product with a soft cloth.
Painted surfaces Hot soapy water:
Clean using a damp dish cloth and dry with a
soft cloth/towel.
Do not use any stainless steel cleaners.
Aluminium and plastic Glass cleaner:
Clean with a soft cloth.
Glass Glass cleaner:
Clean with a soft cloth. Do not use a glass
scraper.
Controls Hot soapy water:
Clean using a damp dish cloth and dry with a
soft cloth/towel.
Risk of electric shock caused by penetrating
moisture.
Risk of damage to the electronics from pene-
trating moisture. Never clean operating con-
trols with a wet cloth.
Do not use any stainless steel cleaners.