Setting The Fan; Intensive Setting; Intermittent Mode; Run-On Function - Siemens LF959RB51 Instruction Manual

Connecting the remote control to the appliance
If the appliance cannot be operated with the remote
control, e.g. after the battery has been changed, the
connection between the remote control and the
appliance must be re-established.
Press and hold the
@
1.
Attach the appliance to the mains voltage.
2.
A long audible signal sounds. The remote control
has been connected to the appliance.
If no audible signal sounds within 30 seconds,
Note:
repeat this procedure.
Extractor hood's control panel
Fan settings display
(
Operating buttons
0
Operating buttons
Explanation
Light on/off/dimming
=
Switches the extractor hood on and off
$
Decrease fan setting
A
Increase fan setting
@
Fan run-on
*

Setting the fan

Always adjust the setting according to the current
Note:
conditions. To eliminate strong cooking smells, select a
high fan setting.
Switching on
Press the button.
@
1.
The fan will start at fan setting
Press the or button to set a different fan setting.
@ A
2.
The appliance has three fan settings and an
Note:
intensive setting. To set the lowest setting,
press once. If you press it more than once, the
A
appliance will switch off again.
Switching off
Press and hold the button until the appliance
A
switches off.
or press the button.
$

Intensive setting

You can use the intensive setting if there is a large
build-up of odours and fumes/vapours.
button.
ƒ .
Press and hold the button until
@
settings display .
Intensive mode runs for four minutes. Once this
Note:
time has elapsed, the appliance will switch back to fan
setting ƒ .

Intermittent mode

Intermittent mode automatically switches on the
extractor hood for 10 minutes every hour. The function
switches itself off again after 24 hours.
This function can be activated from the control panel or
using the remote control.
If intensive mode or the run-on function has been
Note:
activated, the intermittent function will not be available.
Switching on intermittent mode from the control panel
Press the and
$ @
1.
appears in the display.
Press the button. The following fan settings will
@
2.
appear in the display:
Press the and
$ @
3.
confirm the fan setting for intermittent mode.
Switching on intermittent mode using the remote
control
Press the button.
N
1.
Press the button. The following fan settings will
@
2.
appear in the display:
Press the button to confirm the fan setting for
N
3.
intermittent mode.
Pressing any of the buttons (except the button for
Note:
the light) will deactivate intermittent mode.

Run-on function

The run-on function allows the extractor hood to
continue running for a few minutes after it has been
switched off. This eliminates any remaining cooking
smells. The extractor hood will then switch itself off
automatically.
Switching on
If intensive mode has been activated, the run-on
Note:
function will not be available.
Press the button on the control panel or the
*
button on the remote control.
The fan will run for 10 minutes at setting
will flash in the display during this time. Then the fan will
switch itself off automatically.
Switching off
Press the or button on the control panel or the
* $
button on the remote control for the extractor hood.
+
This will deactivate the run-on function immediately.
Operating the appliance
appears in the fan
˜
buttons at the same time until
ƒ~„~‚~ƒ , etc.
buttons at the same time to
will appear in the display.
‚
, etc.
ƒ~„~‚~ƒ
‚ and a dot
en
‚
+
7