Wire Labeling; Choosing A Location - TFC 097A User Manual

Wire Labeling

1.Disconnect and identify each wire.
2.You may wish to tape the wires to the wall to keep them from slip-
ping through the hole in the wall. If the hole in the wall is larger than
necessary, fill it in order to prevent hot or cold air to penetrate the
thermostat. In this manner, the thermostat will behave perfectly.

Choosing a Location

Note: for a new installation, choose a mounting location about five
feet (1.5 meter) above the floor in an area with good air circulation
and away from.
1.Drafts of dead air sports.
2.Air ducts.
3.Radiant heat from the sun or appliances.
4.Concealed pipes and chimneys.
Mounting
Mounting the thermostat onto the wall
1.Remove completely the front housing of the thermostat.
5