Advertisement
NOTE: Power off the power supply when setting the dip switches.
NOTE: Do not connect outputs in series or parallel.
NOTE: When installing power supply, connect to the appropriate sized building breaker or disconnect device for line and neutral
connections, in accordance with local, state or country regulations.
NOTE: The grounding and bonding of the power supply and overall sign shall be done in accordance with National Electric Code
(NEC) Article 600.
Specifications
Performance Data
Input Voltage (VDC)
Input Current (A)
Output Voltage (VDC)
Output Current (ADC)
Output Power (W)
Environmental Operating Temperature Range
Environmental Humidity (non-condensing)
Environmental Storage Temperature Range
Dimensions
This product is intended to be used as a lamp control gear that is installed after the mains control switch.
GE Lighting Solutions • 1-888-MY-GE-LED • www.gelighting.com
GE Lighting Solutions, LLC is a subsidiary of the General Electric Company. Tetra is a trademark of GE Lighting Solutions, LLC. The GE brand and logo are trademarks of the General Electric Company.
© 2014 GE Lighting Solutions, LLC. Information provided is subject to change without notice. All values are design or typical values when measured under laboratory conditions.
GE Lighting 1975 Noble Rd, Cleveland, OH 44112
Min
23
-
2.1
-
-
-40°C
0%
-40°C
9.5 in. x 1.7 in. x 1.2 in. (241 mm x 43.2 mm x 30.5 mm)
Conforms to the following standards:
1 - 8 8 8 - 6 9 - 4 3 - 5 3 3
Typical
24
-
-
-
-
+25°C
+55°C*
-
-
* Maximum case temperature is 85°C
Max
25
4
2.8
5.0
56
95%
+85°C
SIGNXXX-R071514
Advertisement
