Roof Racks - Ford ranger 2012 Mounting Manual

Bull Bar Accessory Mounting Positions
E177160
Item
1 Aerials, antennas and flag mounting location
2 Driving lights mounting location
Aerial/Antenna Cables Routing
WARNINGS:
Ensure that the aerial/antennae cables
have sufficient clearance from hot and
moving parts.
Do not fasten the aerial/antenna cables
to original vehicle wiring, fuel pipes and
brake pipes.
Keep the aerial/antenna and power
cables at least 100mm from any
electronic modules and airbags and
associated wiring.
NOTE: Make sure the sealing integrity is
maintained to avoid water ingress into the cabin
while routing the cables through the grommet.
Aerial/Antenna cables should be routed from the
engine bay into the cabin area through the existing
grommet. There is a service nib provided on the
grommet.
Refer to Exterior lighting - Additional external
lamps for driving lights cable routing.
FORD RANGER 2012
2 2
Description

5.1.8 Roof Racks

Roof racks may be fitted to all variants as
illustrated in figure, providing the following is
satisfied:
• The carried load does not exceed 80kg (Body
Builder to ensure owner's hand book identifies
this limitation).
• The carried load does not exceed 300mm load
height (converter to ensure owner's
information book identifies this limitation).
• The load is evenly distributed (converter to
ensure owner's information book identifies this
limitation).
• The rack and subsequent carried load is
supported in the roof drip rails irrespective of
rack retaining method.
1
Date of Publication: 12/2014
71