Installation / Performance Check List; Electrical System - Intertherm M1B Series Installation Instructions Manual

attEntIon InstallERs:
It is your responsibility to know this product better than your customer.
This includes being able to install the product according to strict
safety guidelines and instructing the customer on how to operate
and maintain the equipment for the life of the product. Safety should
always be the deciding factor when installing this product and us-
ing common sense plays an important role as well. Pay attention to
all safety warnings and any other special notes highlighted in the
manual. Improper installation of the furnace or failure to follow safety
warnings could result in serious injury, death, or property damage.
These instructions are primarily intended to assist qualified individuals
experienced in the proper installation of this appliance. Some local
codes require licensed installation/service personnel for this type of
equipment. Please read all instructions carefully before starting the
installation. Return these instructions to the customer's package for
future reference.
InstallatIon aDDREss:
CITY:
UNIT MODEL #
UNIT SERIAL #
Unit Installed Minimum clearances
per Table 1, (page 6)?
InstallER naME:
CITY:
Has the owner's information been
reviewed with the customer?
Has the Literature Package been
left with the unit?
PRoPosItIon 65 WaRnInG:
WaRnInG: this product contains chemicals
known to the state of california to cause
cancer.
WaRnInG: this product contains chemicals
known to the state of california to cause birth
defects or other reproductive harm.
Specifications & illustrations subject to change without notice or incurring obligations (10/15).
O'Fallon, MO, © Nortek Global HVAC LLC 2015. All Rights Reserved.

InstallatIon / PERFoRMancE cHEcK lIst

STATE:
YES NO
STATE:
YES NO
YES NO

ElEctRIcal sYstEM

Electrical connections tight?
Line voltage polarity correct?
Supply Voltage: ________________________________ VOLTS
Has the thermostat been calibrated?
Is the thermostat level?
Is the heat anticipator setting correct?
Gas sYstEM
Gas Type: (circle one)
Gas pipe connections leak-tested?
Gas Line Pressure: ........................................................ (in - W.C.)
Installation Altitude:............................................................(FT.)
Deration Percentage: .........................................................(%)
Furnace Input:....................................................................(Btuh)
Supply Air Temperature: ...................................................(° F)
Return Air Temperature: ...................................................(° F)
Temperature Rise: ............................................................(° F)
coMBustIon aIR & VEntInG sYstEM
Is there adequate fresh air supply
for combustion & ventilation?
Vent free from restrictions?
Filter(s) secured in place?
Filter(s) clean?
Flue connections tight?
Is there proper draft?
YES NO
YES NO
YES NO
YES NO
YES NO
Natural
Propane
Gas
YES NO
YES NO
YES NO
YES NO
YES NO
YES NO
YES NO
709243D (Replaces 709243C)