1. Manuals
  2. Brands
  3. LAAWA Manuals
  4. Trimmer
  5. GT2518
  6. Original instruction manual

LAAWA GT2518 Original Instruction Manual

Electric grass trimmer
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
ORIGINAL INSTRUCTIONS
MANUAL
ELECTRIC GRASS TRIMMER
Model GT2518
WARNING: Read the instructions before using the product
Before initial start-up, please read through these operating instructions carefully
prior to using the machine. Keep the instructions safe and pass them on to any
subsequent user so that the information is always available.
Serial Number:

Advertisement

Table of Contents
loading

Related Manuals for LAAWA GT2518

Summary of Contents for LAAWA GT2518

  • Page 1 ORIGINAL INSTRUCTIONS MANUAL ELECTRIC GRASS TRIMMER Model GT2518 WARNING: Read the instructions before using the product Before initial start-up, please read through these operating instructions carefully prior to using the machine. Keep the instructions safe and pass them on to any subsequent user so that the information is always available.
  • Page 2 INTRODUCTION This electric grass trimmer has been designed and made according to LAAWA’s high standards of reliability, simplicity and safety of use. If properly maintained, the product will last for long without problems. Any use which is not expressly permitted in these instructions, can lead to damage of the appliance, can be seriously dangerous for the user and not allowed.
  • Page 3 SASSA SAFETY INSTRUCTIONS ATTENTION ! The safety instructions have to be strickly observed by using the product. For your safety and the safety of the others, read this manual carefully before any use. Keep this manual in a safe place for any future reference. Safe and proper use of the product •...
  • Page 4 • Disconnect the plug from the power supply source, before doing any maintenance / inspection / repair.. • Verify that the aeration holes are always clean and free of dust / debris. . The use of this appliance is allowed only if the safety instructions are strickly followed.
  • Page 5 Before any use, verify the safety devices of your appliance, in particular the main power cord / extention cable, the switch and the protection cover. Always work with safe, intact and in good conditions appliances. • Use the appliance only if all safety devices are assembled. •...
  • Page 6 areas. Never use the trimmer in the proximity of flammables liquids or gases. Risks of fire or explosion! Remember that the operator is responsible for the accidents or hazards • occurring to other people or their property. • Always check that the ventilation openings are free. Before any cleaning, maintenance, replacement, it is mandatory to unplug the power socket.

  • Page 7: Maintenance

    • For the outdoor work, only extension cables duly approved for outdoor must be used. The extension cables used must have a min. cross section of 1,5 mm2 (60245 IEC 53 ou 60227 IEC 53 ; in some countries, the extension cables shall be type 60245 IEC 57). Plug connections must be equipped with protective contacts and be protected against splashes.

  • Page 8: Definition Of Symbols

    DEFINITION OF SYMBOLS Precaution that involve your safety You must read the operating instructions carefully. Pay attention that bystanders are not injured by objects thrown out from the machine. Keep bystanders a safe distance away from the machine. Wear eye protection. Wear ear protection.

  • Page 9: Technical Data

    TECHNICAL DATA Frequency: 230V~, 50Hz Power: 320W No load speed: 11200/min Cutting width : 25 cm Wire diameter : 1.2 mm Wire length 2 x 3 mt Weight 1.27 kg Noise pression level at operator’s position (EN 786): =86 dB(A) K=3dB Measured sound power level (EN 786): =94 dB(A) K=2dB...

  • Page 10: Assembling Instructions

    ASSEMBLING INSTRUCTIONS Before any work on the product, the plug must be disconnected. Only use genuine parts – when assembling parts, pay special attention to the cutting device. Risk of injury ! Fix the 2 handle parts together. Verify that the power cable is not jammed .
  • Page 11 INFORMATION ABOUT CUTTING A short wire or a blunt wire does not cut cleanly. That is why, if you notice a decrease in cutting performance, you should check if the spool still contains enough wire. To do this, disconnect the plug! You will find a description how to replace wire at “Replacement of the cutting device”.
  • Page 12 REPLACEMENT OF THE WIRE SPOOL (FIG E&F) Unplug the power socket. Turn up side down the unit, so to have the head on top. The cover closing the nylon spool is just clipped. Push the retainer located on spool holder and turn the cover (1) of spool holder (3). Remove the empty spool (2).

  • Page 13: Spare Parts

    SPARE PARTS DESCRIPTION REF. NYLON HEAD COVER ……………………………………CLGT251807 NYLON WIRE REFILL …………………………………MAC911045 SPRING ………………………………………….………..CLGT251809 NYLON HEAD BOTTOM…………………………………….CLGT251810 PROTECTOR……………………………………………….CLGT251811 PLANTS PROTECTOR ………………………………………CLGT251812 Attention ! Repair, special maintenance and all interventions on the cutting device must be imperatively made only by authorized service station/workshop.
  • Page 14 : Yuxi WANG, quality engineer declare that the following product under brand : LAAWA Model reference : Eletric grass trimmer 320W GT2518 (Factory model: GT2518 / GARDIF Ref.: CBE911422) (the electric grass trimmer is a device with flexible nylon wire or similar cutting...

Table of Contents