Panasonic DMR-EH75VP Service Manual page 35

8.2.4.2. (VHS) Condition for clearing the self-diagnosis history
1. A case of that press the FF key and the EJECT key simultaneously over 5 seconds.
8.2.4.3. (VHS) Indication of the self-diagnosis history.
1. The self-diagnosis histories and its supplementary data could be indicated on the FIP with Service mode of number from 3 to
5.
2. The procedure of setting the service mode and the format if the indication are same as usual.
Both the Error numbers and its supplementary data of history 1, 2and 3 are indicated by selecting the Service mode 3, 4 and 5 as
shown above.
In case of that any Error has not been memorized, the Error number and its supplementary data is indicated as " - ".
8.2.4.4. (VHS) Display of Supplementary Data 3 and 4
During displaying the Self-Diagnosis History, press [STOP] key on front panel to change the display.
*Example of Display
A: Service Mode Number.
B: Supplementary Data 3...Mechanism process shifting Number.
C: Supplementary Data 4...LM(Loading Motor information)
*Display of
occurred while mechanism was between REV position and LOAD position.
<Supplementary Data 3>
[EJECT]
10: PLAY ® passing REV
11: passing REV
12: passing REV ® LOAD
(Capstan STOP)
13: LOAD ® DOWN
14: DOWN ® EJECT
15: EJECT completion
[PLAY]
20: Cylinder starting up, Phase drawing
21: Audio muting, VV selection
[P.ON]
-- Process of turning on power
[P.OFF]
70: PLAY ® P.OFF
means that " Loading Motor turns ON when [EJECT] button was pressed, but an error has
[FF]
U0: PLAY ® STOP F
U1: STOP F ® FF
U2: FF starting up
[REC]
30: Cylinder starting up, Phase drawing
31: REC signal output
[STILL ® PLAY]
48: Tape sending
[CUE ® PLAY]
4A: Finishing edge Checking, Tape sending
4-: PLAY Checking, Tape sending
35
[REW]
A0: PLAY ® STOP F
A1: STOP ® REW
A2: REW starting up
[STILL]
40:Turning forward
41:Speed is 0, Capstan is OFF
[CUE]
49: x2 speed sending, Turning point of
Calculating remains
[REV]
80: PLAY ® P.OFF
81: Rewinding
P.OFF ® REV
DMR-EH75VP