Advertisement
Available languages
Available languages
The Quick Guide is for quick installing and connecting the Fisheye IP Camera. For details, please refer to the IP Camera's User
Manual.
Camera's Connectors
N. Connector
1 Power
2 RJ-45
3 Alarm & Audio I/O
4 Reset Button
5 Micro SD Card Slot
IP Camera Installation
Please follow the instructions below to complete IP Camera installation.
Power up the Camera
To power up the IP Camera, please plug the camera's DC 12V/ AC 24V cable into the power terminal block.
Alternatively, connect the Ethernet cable to the camera's RJ-45 port and plug the other end of the cable into a PoE switch
.
NOTE: If using PoE, make sure Power Sourcing Equipment (PSE) is in use in the network.
Ethernet Cable Connection
Connect one end of the CAT5 Ethernet cable to the RJ-45 connector of the IP Camera, and the other end of the cable to the
network switch or PC.
6
N. pin
12 VCC
1
Power
2
Reserved
3
GND
24 VCA
1
Power-1
2
GND
3
Power-2
-
10/100 Mbps Ethernet/ PoE
-
Alarm & Audio I/O
Restore to default setting; press the button with a proper tool
-
For video recording storage
-
Definition
Power connection
Contact us to purchase the
cable
Remarks
EN
Advertisement
