Table of Contents
Advertisement
13-1-2 Circuit description [FLY-Back PWM(Pulse Width Modulation)] Control
13-1-2 (a) AC Power Rectification/Smoothing Terminal
1) PDS01, PDS02, PDS03, PDS04 : Convert AC power to DC(Full wave rectification).
2) PEF10 : Smooth the voltage converted to DC.
3) PCD01, PCD02, PBS01 : Noise removal at power input/output.
4) PVA1 : SMPS protection at power surge input.
13-1-2 (b) SNUBBER Circuit : PDS11, PCD12, PRS13, PCD11, PPS12
Vswitch
dt
0
13-1-2 (c) Driving circuit
When Vin supplied, driving current Ig occurs throuhg the PICF1. By this I
and the Vb is inducted to base winding coil NB. By inducted Vb, Ib start flow and the V
sustained stable. Ib is constant and I
shortage and PICF1 is cut OFF (S/W OFF).
Samsung Electronics
Inverted power
by leakage
inductance
Toff
Fig. 13-7
increases in Proportion to time. After constant time passed Ib become to
1
1) Prevent residual high voltage at the terminals of
switch during switch off/Suppress noise.
High inverted power occurs at switch (PQR11) off,
because of the 1st winding of transformer :
(V=-L1 xdi/dt. L1 : Leakage Induction)
A very high residual voltage exist on both terminals
of PICF1 4, 5~8pin because dt is a very short.
2) SNUBBER circuit protects PQR11 from damage
through leakage voltage suppression by RC,
(Charges the leakage voltage to PDS11, PER13,
t
PCD12 and discharges to PRS11, PRS12).
(=Hfe
1
Circuit Operating Descriptions
x Ig) occurs throug the PICF1
voltage of PQR11 is
CC
13-3
Advertisement
Chapters
Table of Contents
