Hitachi IJ UX Instruction Manual page 248

No.
Ambient
85 Temperature Too
Low
87 Ink Pressure High
88 Battery Low C
93 Ink Pressure Low
Product Speed
95
Matching Error
129 Model-key Failure Model-key recognition failed.
Language-key
130
Failure
131 Upgrade-key Fault Upgrade-key recognition failed.
Circulation System
135 Cooling Fan
Fault
Inside Temperature
136
Too High
RFID Reader
151
Failure
Makeup Ejection
152
Pressure Low
Ink Level
161
Sensor Broken 2
Makeup Level
162
Sensor Broken 2
9-11 ●On-screen message descriptions
Message
The ambient temperature is below the
proper level.
Ink pressure is higher than the
recommended value.
The internal battery in controller section is
low.
Ink pressure is lower than the
recommended value..
The encoder pulse rate exceeds the
available printing speed.
Language-key recognition failed.
The cooling fan of the circulation system
area is faulty.
The temperature inside the printer is
increasing.
RFID reader recognition failed.
Makeup ejection pressure is getting low.
The level sensor in the ink reservoir does
not work properly.
If IJ printer continues running as it is,
IJ printer will regard it as "Ink low " and
stop the ink jet.
The level sensor in the makeup reservoir
does not work properly.
If IJ printer continues running as it is,
IJ printer will regard it as "Makeup low "
and stop the ink jet.
Meaning of message Remedy
● Ensure that the ambient tem-
perature is within the operat-
ing temperature limits.
● Adjust the pressure-reducing
valve to correct the pressure.
( Technical manual 6.9)
● Contact your nearest local
distributor.
● Replace the internal battery
in engine section and set the
data/time. ( 6.2).
● Adjust the pressure-reducing
valve to correct the pressure.
( Technical manual 6.9)
● Slow the print target speed.
● Decrease N in the ink drop
use percentage (1/N).
( 4.14.1).
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Prease confirm the ink
recovery status.
● Replace the air filter or make
the space around printer.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.