Panasonic DMR-E75VP Service Manual page 32

DMR-E75VP
12.4.4. (VHS) Display of Supplementary Data 3 and 4
During displaying the Self-Diagnosis History, press [STOP] key on front panel to change the display.
*Example of Display
A: Service Mode Number.
B: Supplementary Data 3...Mechanism process shifting Number.
C: Supplementary Data 4...LM(Loading Motor information)
*Display of
occurred while mechanism was between REV position and LOAD position.
<Supplementary Data 3>
[EJECT]
10: PLAY ® passing REV
11: passing REV
12: passing REV ŮLOAD
(Capstan STOP)
13: LOAD ® DOWN
14: DOWN ® EJECT
15: EJECT completion
[PLAY]
20: Cylinder starting up, Phase drawing
21: Audio muting, VV selection
[P.ON]
-- Process of turning on power
[P.OFF]
70: PLAY ® P.OFF
<Supplementary Data 4> (LM Information)
Result of request of driving Loading Motor.
Display
1 There was no change of mechanism position. (Loading Motor was OFF)
2 There was some change of mechanism position. (Loading Motor was ON)
means that " Loading Motor turns ON when [EJECT] button was pressed, but an error has
[FF]
U0: PLAY ® STOP F
U1: STOP F ® FF
U2: FF starting up
[REC]
30: Cylinder starting up, Phase drawing
31: REC signal output
[STILL ® PLAY]
48: Tape sending
[CUE ® PLAY]
4A: Finishing edge Checking, Tape sending
4-: PLAY Checking, Tape sending
32
A0: PLAY ® STOP F
A1: STOP ® REW
A2: REW starting up
[STILL]
40:Turning forward
41:Speed is 0, Capstan is OFF
[CUE]
49: x2 speed sending, Turning point of
Calculating remains
[REV]
80: PLAY ® P.OFF
81: Rewinding
P.OFF ® REV
Description
[REW]