4-2-2. No Video (HDMI 1, 2, 3, 4 - Digital Signal)
Note
Refer to the next page to check the location such a CN201 or IC201 SVC Manual mentioned.
Symptom
•
Audio is normal but no picture is displayed on the screen.
•
Check the HDMI source.
Major
•
Check the HDMI switch.
checkpoints
•
This may happen when the LVDS cable connecting the Main Board and the Panel is
disconnected.
1
Diagnostics
2
Caution
Make sure to disconnect the power before working on the IP Board.
Power indicator LED is off.
Lamp(Backlight) on, no video ?
Yes
Check the HDMI source and check the
connection of HDMI cable ?
Yes
Check the signal at Input of Main Board ?
HDMI1 Clk
-
Pin #10, #12 of CN602_H2
•
DATA
Pin #7, #9, #4, #6, #1, #3 of
CN602_H2
HDMI2 Clk
-
Pin #10, #12 of CN603_H3
•
DATA
Pin #7, #9, #4, #6, #1, #3 of
CN603_H3
HDMI3 Clk
-
Pin #10, #12 of CN604_H4
•
DATA
Pin #7, #9, #4, #6, #1, #3 of
CN604_H4
HDMI4 Clk
-
Pin #10, #12 of CN601_H1
•
DATA
Pin #7, #9, #4, #6, #1, #3 of
CN601_H1
Yes
Check the LVDS clk signal at output of
Main Board. (TX)
TX2_CLK : ODD_TXCLK_DN/DP
-
TX4_CLK : EVEN_TXCLK_DN/DP
-
Yes
Check the LVDS cable?
Replace the T CON / LCD panel?
No
Check a set in the 'Stand-by mode'.
No
Input the HDMI signal properly.
Check CN601~4.
Check HDMI cable.
Change the Main Ass'y.
No
Check IC1001(X12).
Change the Main Ass'y.
Check IC1001(X12).
No
Change the Main Ass'y.
No
Please, Contact tech support.
4. Troubleshooting
or
4-7