Receiver Control; Communication Settings - Encoded Media IPTV Receiver 250 Installer's Manual

Receiver Control

COMMUNICATION SETTINGS

To gain access to the Receiver, you can connect to it over an RS-232 connection
using the following comms settings:
Baud Rate 9600
Data Bits 8
Parity None
Stop Bit 1
Flow Control None
Device Type DTE
Note: null modem cable required
You can also connect over IP to port 5004 on your Receiver:
Once connected, you will be challenged to provide a username and password which
by default are as follows:
Username engineer
Password iptv250

PLEASE NOTE!
You are limited to a maximum of five concurrent telnet sessions. Once a sixth
connection is made, the first connection will be terminated.
Page 6 of 21