Table of Contents
Advertisement
1
Remove the Antenna and Get Tools
CAUTION
For your own safety, be sure to disconnect
power from all wired components before
performing this procedure.
IMPORTANT!
Always lift the antenna by the baseplate and
never by the radome or any portion of the
internal antenna assembly (see
a. Before you begin, record the system's current
network settings. You might need to be re-
enter these settings later. Refer to the
TracVision HD7 Installation Guide or User's
Guide for complete details.
b. Remove the antenna from the vessel and
move it to a location suitable for service.
NOTE: This procedure requires handling exposed
electronic parts and components, and might take over
two hours to complete. Ensure that you take the
necessary grounding precautions before handling, and
perform this procedure in an adequate workspace.
c. Gather the tools and materials listed below.
You will need these items to complete the
installation.
• #1 Phillips screwdriver
• #2 Phillips screwdriver
• 9/32" open-end wrench
• 5/16" nut driver
• Cutting pliers
• 2.5 mm ball-end hex wrench
(supplied)
• 9/64" ball-end hex wrench (supplied)
• 3/32" ball-end hex wrench (supplied)
• 1/16" hex wrench (supplied)
• 7/64" hex wrench (supplied)
• Needle-nose pliers
• Ruler, or equivalent
• Scribe, or equivalent
Figure 1 Antenna Radome/Baseplate
Figure
1).
Radome
Baseplate
3
Advertisement
Table of Contents
