Table of Contents
Advertisement
20
model no. 009-5097-2 / contact us 1-888-942-6686
The following chart lists common operating issues and solutions. Please read it
carefully and follow all instructions closely.
Problem
Unit does not
start.
DISPOSING OF THE TOOL
If the tool is damaged beyond repair, do not throw it out. Bring it to the
appropriate recycling facility.
WARNING!
!
If any of the above symptoms appear while the tool is in use, turn it off and
disconnect it from the power supply immediately. Failure to heed this
warning will result in serious personal injury.
NOTE:
For further information, please call 1-888-942-6686.
Possible Causes
1. Preset pressure
setting is below the
actual pressure of the
item that you are
inflating.
2. Cord is not plugged in.
3. Circuit breaker is
tripped.
4. Fuse in 12 V DC
power cord is blown.
Solutions
1. Adjust the preset pressure
setting to higher pressure.
2. Plug into a working 120 V AC
or 12 V DC power outlet.
3. Reset circuit breaker.
4. Replace the 10 A fuse in
12 V DC power cord.
Hide quick links:
Advertisement
Table of Contents
