How To Extend The Shaft - Bottom Line Fishin' Buddy 1200 Manual

The c-clamp is the most versatile and portable way to mount the Buddy to
your boat. Loosen the c-clamp by turning it counter-clockwise and then
place the bracket around the gunnel or transom, resting it on the top
surface (or as far down as possible). Then, tighten the c-clamp by hand.
Caution: Do not over-tighten the c-clamp or permanent damage may
occur. If the mounting bracket is not stable after tightening by hand,
try repositioning the bracket.

How to Extend the Shaft

Once the bracket is in place, slide the Buddy shaft through the bracket and
observe how deep the end of the shaft rests in the water. For proper
operation, the transducer at end of the shaft must be at least 8 inches below
the water surface. To extend the shaft, turn the collett (see Figure 1) until
the inner shaft slides freely. Extend to the required length and then re-
tighten the collett. Then, use the pivot adjustment knob to set the shaft
vertical and true.
Note: The inner shaft will come completely out, allowing you to turn
the transducer 180°. Be sure that the Sidefinder beam (see Figure 5) is
pointed in the direction that you are looking for fish with the Sidefinder
feature.
Note: Make sure that there are no air bubbles on or around the
transducer when it is in the water. You can remove the air bubbles by
rubbing your hand on the plastic. You should periodically clean the
transducer to remove oil build-up.
Caution: Over-extension of the shaft may cause excessive pressure on
the mounting bracket if the boat is moving. Remove the Buddy from
the bracket before driving the boat.
Start fishing!
The Fishin' Buddy is designed to run automatically with just a press of the
power button. To get the most out of your Buddy, read the next section on
functions and features.
4