Specifications - Bottom Line Fishin' Buddy 1200 Manual

S
PECIFICATIONS
Unit dimensions shaft extended
Unit dimensions shaft not extended
Total weight
Display viewing area
Display pixel matrix
Bottom depth range
Sidefinder range
Transducer frequency (bottom & side)
Transducer cone angle (bottom & side)
Power requirement
Battery life (night-light off)
Computrol reserves the right to change specification without notice.
Notice: The bottom depth range specified above is under best
conditions. No guarantee of maximum depth capability is made due to
the unlimited types of waters in which the Buddy is used.
Caution: Facing the screen toward the sun for extended periods may
cause the display to reach its upper temperature limit and turn black. If
this occurs and you cannot adjust it lighter (see
page 5), immediately cover the screen or turn it away from the sun.
Caution: The Buddy may not operate properly if the outside
temperature is below 14°F (-10°C) or exposure to the sun or other heat
sources causes the case to reach 140°F (60°C). Permanent damage will
occur to the liquid crystal display if stored or used where the
temperature is below -4°F (-20°C) or exposure to the sun or other heat
sources causes the case to reach 158°F (+70°C). This type of damage
is not covered by the warranty.
51" x 6.5" x 8"
34" x 6.5" x 8"
5lbs
3.3" x 2.4"
128Vx64H
Up to 240 feet
Up to 120 feet
455KHz
9 degrees
3 alkaline "C" cell batteries
Up to 40 hours
1 3
Menu on
CONTRAST