To Select Connected Equipment - Philips pixel plus Instruction Manual

Stereo amplifier and two extra front speakers

To select connected equipment

Press the v key on the remote control repeatedly to select
to where you connected your equipment at the back or the right side of your TV.
Remark : Most equipment (decoder, recorder) carries out the switching itself, when it is switched on.
Cinema Link surround receiver
See the separate supplied Cinema Link instruction manual.
Attention: the sound info on screen will not correspond with the actual sound reproduction.
Recorder or DVD with EasyLink
The recorder (VCR or DVD+RW) or DVD can
be operated with the remote control via the
Recorder or DVD menu on screen.
Recorder
Ò
Rwd Play
DVD
Ò p
Prev. Play
16
AUDIO
p ‡ π †
Stop Play Ffw
‡ π †
Stop Play Next Eject
&
Connect the audio cables to the
of your amplifier and to
back of your TV.
é The output level is controlled by the volume
control of the amplifier.
Note: Switch off the TV and your audio amplifier
before connecting them. Set the audio amplifier's
volume to minimum.
& Press the
é
Select the
cursor up/down.
"
Press the cursor left/right, up/down to select
one of the recorder or DVD functions.
®
Ï
The key ® for recording can be operated in the TV
Rec Eject
mode.
If your EasyLink recorder has the system standby
function, when you press the B key for 3 seconds,
Ï
both TV and the recorder are switched to standby.
AUDIO L
, or
EXT1 EXT2, EXT3
key on the remote control.
MENU
Recorder or
DVD
input
AUDIO
and at the
R
according
SIDE
menu with the