Philips 43PP8545 User Manual page 12

Using the Menus: Picture
Using Auto IntelliSense
Your projection TV has three colour projection tubes: one for
red, one for green, and one for blue. When mixed in proper
proportion, the beams of light coming from the tubes can produce
any colour. To create a clear picture, however, these colour beams
must be precisely aligned. This alignment is called convergence.
Bumps and vibrations, moving the set, or the presence of magnetic
fields can cause the colour beams to become improperly aligned,
or misconverged, resulting in a fuzzy picture. Using the Auto
®
IntelliSense feature, you can automatically adjust convergence in
20 seconds or less.
Note: Allow the TV to warm up for 20 minutes before using Auto
®
IntelliSense .
Activating Auto IntelliSense
Onscreen Menu
Select INTELLISENSE in the PICTURE menu.
Press the cursor left or right to activate Auto IntelliSense
Picture convergence will be adjusted automatically in 20
seconds.
Activating Auto IntelliSense
With the TV on, press the INTELLISENSE key on the front of
the TV. Picture convergence will be adjusted automatically in 20
seconds.
Note: You can also manually adjust picture convergence to suit your
personal preferences or to further fine-tune the picture. See the next
section on using the MANUAL CONVERGE controls.
Using Manual Converge: Converge Red/Blue
Using the Auto IntelliSense
convergence in 20 seconds or less (see the previous page). Also,
if you desire, you can use the Manual Converge controls to
make additional convergence adjustments to suit your personal
preferences or to further fine-tune the picture.
Note: Allow the TV to warm up for 20 minutes before adjusting
convergence.
Select MANUAL CONVERGE in the PICTURE menu.
Press the cursor down and select either CONVERGE RED or
CONVERGE BLUE.
Note: If various images in the picture have red outlines, select
CONVERGE RED. If various images in the picture have blue
outlines, select CONVERGE BLUE.
Use the cursor right, left, up or down to adjust the cross hair
until the colour outline is gone. The adjustment is automatically
saved in the TV's memory when you exit the adjust mode.
Press the MENU key to return or the OSD key to switch the
menu off.
Check the TV picture. If any colour outlines remain around
the images, use the MULTIPOINT RED (for red outlines) or
MULTIPOINT BLUE (for blue outlines) control. See the next
section for instructions for using those controls.
®
Through the
®
Using the TV Key
®
®
feature, you can automatically adjust
®
Press to begin
automatic picture
convergence
12
TV Keys