Table of Contents
Advertisement
3.1.5 Removing the rear panel (See Figure 8, Figure 9)
• Prior to performing the following procedure, remove the top
cover.
(1) Remove the eight screws F attaching the rear panel.
(2) Disconnect the power cord from connector
power supply board
(3) Remove tie band.
3.1.6 Removing the servo control and signal output terminal board. (See Figure 9)
• Prior to performing the following procedure, remove the top
cover/rear panel.
(1) Remove the two screws G attaching the servo control and
signal output terminal board.
(2) Disconnect the card wire from connector CN101, CN401,
CN631,
CN503
on the servo control and signal output ter-
minal board.
(3) Disconnect the flat wire from connector CN902,
the power supply board.
3.1.7 Removing the power supply board. (See Figure 9)
• Prior to performing the following procedure, remove the top
cover/rear panel.
(1) Remove the three screws H attaching the power supply
board.
(2) Disconnect the wire from connector CN901, CN902,
CN903, CN904,
CN651
(3) Disconnect the socket wire from socket P901 on the power
supply board.
3.1.8 Removing the memory card reader board. (See Figure 10)
• Prior to performing the following prcedure, remove the front
panel assembly.
(1) Remove the two screws I attaching the bracket.
P901
on the
CN903
on the power supply board.
F
G
CN503
CN101
CN401
CN631
Servo control and signal
output terminal board
on
I
Memory card reader board
Rear panel
F
F
Fig.8
CN901
H
G
H
Power supply board
CN651
CN902,CN903
Fig.9
Front panel assembly
I
Fig.10
(No.XA004)1-11
H
P901
CN904
Advertisement
Table of Contents
