Hdd Bracket; Dvd-Ram Drive - Panasonic DMR-E85HP Service Manual

DMR-E85HP / DMR-E85HPC
3. Lift up HDD with super sheet vertically and remove super
sheet.
Handling of HDD
The following precautions should be taken when handling HDD.
a. Never give an impact to HDD. (Even a drop from 1cm height can
be a cause of HDD failure.
b. When placing HDD on a workbench, provide a mat on a bench for
shock absorption and anti-static purposes.
c. When installing HDD, release it from your hands only after
confirming that it is fully set on the chassis.
d. Avoid stacking up HDD.
e. HDD is unstable and easy to fall. Do not stand it on its side face.
f. When handling HDD, hold its side faces to avoid static hazard.
g. Do not place HDD on its wrapping bag after removal. (Prevention
of static hazard
h. Use a screwdriver with low impact and anti-static features.
i. To replace HDD, remove the vertical short-circuit pin.
(Keep the horizontal short-circuit pin in its place)
Note:
When replacing HDD, please make the rear jumper slave or
cable select configuration.
(same configuration as HDD to exchange)

11.8. HDD Bracket

1. Remove 4 screws (B) and HDD Bracket with 2 Insulation
Sheets.

11.9. DVD-RAM Drive

1. Remove 3 Screws.
2. Pull out DVD-RAM Drive vertically so to remove it with
Connector.
28