Mercedes-Benz SL SERIES Operator's Manual page 302

At a glance
300
The example describes how to set the sur-
round sound for radio mode.
To switch surround sound on/off: press
X
the $ button.
The radio display appears. You will hear the
last station played on the last waveband.
Select Sound
X
cVd the COMAND controller and press W
to confirm.
Select Surround
X
Select Logic7
X
ing cVd the COMAND controller and press
W to confirm.
Depending on your selection, surround
sound is switched on or off and the menu is
exited.
To exit the menu without saving: press
X
the k back button or slide XVY the
COMAND controller.
i
Please note the following: for the opti-
mum audio experience for all passengers
®
when Logic7
should be set to the center of the vehicle
interior.
You will achieve the best sound results by
playing video DVD media.
MP3 tracks should have a bit rate of at least
128 kbit/s.
Surround sound playback does not func-
tion for mono signal sources, such as for
AM radio mode.
If radio reception is poor, e.g. in a tunnel,
you should switch off Logic7
otherwise switch dynamically between
stereo and mono and cause temporary
sound distortions.
On some stereo recordings, the sound
characteristics may differ from conven-
tional stereo playback.
i
The Logic7
round sound experience for every
passenger when playing stereo recordings,
for example. It enables optimum playback
of music and films on CD or video DVD with
by sliding VÆ and turning
and press W to confirm.
® ®
On or Logic7 Off
is switched on, the balance
®
, since it may
®
On function creates a sur-
multichannel audio formats, such as MLP,
dts or Dolby Digital. This results in sound
characteristics like those intended by the
sound engineer when the original was
recorded.
i
If you select
tem plays the tracks as stored on the
medium. Due to the design of the
passenger compartment, an optimum
audio experience cannot be guaranteed for
all passengers.
by turn-
Bang & Olufsen sound system
You can optimize the sound in the vehicle with
the Bang & Olufsen sound system and the
True Image™ sound technology. The
Mode function enables you to focus the selec-
ted sound setting within the vehicle.
The example describes how to set the opti-
mum sound for radio mode.
Selecting the sound setting for True
Image™
Press a number key, such as $.
X
Select Sound
X
cVd the COMAND controller and press W
to confirm.
Select Bang&Olufsen
X
firm.
A menu appears. A # dot marks the current
setting for True Image™.
Select reference
X
W to confirm.
reference
R
®
Logic7 Off, the sound sys-
by sliding VÆ and turning
and press W to con-
or surround and press
Sound