Philips BM60 User Manual page 15

Create a group
Note
•
Whenever you create a group, the first speaker that
you enable the group function will act as the master.
1
Hold GROUP on the first speaker for 3
seconds (The master).
2
Hold GROUP on a second speaker for 3
seconds (The slave).
3
Wait for 15 to 30 seconds for connection
setup.
4
Repeat steps 1 to 3 to add more slave
speakers one by one.
Note
•
You can only add slave speakers one by one. Each time
when you add a slave speaker, first press and hold
GROUP on the master speaker until the indicator on
the button flashes and the speaker beeps.
•
If the signal strength indicator on a slave speaker shows
that the signal is poor, move it closer to the master
speaker.
You can add any of the following speakers into
the existing group or create a new group with
them:
• A speaker with factory default settings
• A master speaker that has no slave
connected to it
• A slave speaker that is disconnected
from its master (with the GROUP
indicator flashing)
Play from the master to the whole
group
Note
•
In Bluetooth mode, music play pauses when there is an
incoming call or video recording is in progress on the
connected mobile phone.
• If this speaker (BM60) acts as the master,
select a source and play to the whole
group of speakers.
Change master
You can change the current master in a group
easily. For example, in Bluetooth mode, when
your mobile phone loses connection with the
current master speaker, you can set the closest
slave speaker as the master.
EN 13