Advertisement
Quick Links
Advertisement
Summary of Contents for XCITE 1001P
- Page 1 XCITE Reso-not Damping System XCITE Owner’s Manual 1001P FIELD TEST POWER SUPPLY RDS - 1 Xcite Systems Corporation 675 Cincinnati Batavia Pike Cincinnati, Ohio 45245 Tel: (239) 980-9093 Fax: (239) 985-0074 Email: info@xcitesystems.com Web: www.xcitesystems.com ...
- Page 2 Copyright 1997 Xcite Systems Corporation This document contains proprietary information of Xcite Systems Corporation and is tendered subject to the conditions that the information (a) be retained in confidence (b) not be reproduced or copied in whole or in part and (c) not be used or incorporated into any product except under an express written agreement with Xcite Systems Corporation.
- Page 3 1001P Field Test Power Supply...
-
Page 4: Theory Of Operation
Field Test Power Supply Introduction The Xcite 1001P Field Test Hydraulic Power Supply is designed to fulfill the power requirements for Xcite Series Controlled Force hydraulic Exciters and other actuators that do not require an average flow of more than 1.2 GPM. This power supply is completely portable and can be used in a wide variety of test environments. - Page 5 T1. The voltage selector switch (107PB) selects operation of the entire 1001P Hydraulic Power Supply from either 115 VAC or 230 VAC, 60 Hz. Drawing B-30222 and B-30224 depicts the voltage selector switch in the 230 Volt position.
- Page 6 Xcite Master Controller, if necessary. It should be noted that the Emergency Stop Switch MUST be pulled out for the 1001P Power Supply to operate. If it is depressed (stays depressed once pushed), the unit will NOT operate.
- Page 7 The system should not be operated with less than 3.5 gallons of oil. 3.7. Voltage Selector Switch This switch allows the 1001P Hydraulic Power Supply to be used with either 115 VAC or 230 VAC 60 Hz power, single phase. See 2.2. and B-30224 3.8.
-
Page 8: Care And Maintenance
XCITE Field Test Power Supply 4.4. Connect the power cord to the power source, making sure that the power indicator lamp is lit. Use black and white wires for voltage, green for ground. The red wire is NOT used. NOTE: The unit should NEVER be operated with the hoses coiled, nor should anything be set on the hoses, nor should they be driven over. -
Page 9: Troubleshooting
See Drawing B-30221 - Item #13 for filter model number Troubleshooting This section lists the most common problems encountered, as well as their probable causes. If the problem cannot be readily corrected, contact your Xcite Customer Ser- vice Representative. Problem Probable Cause Power lamp is not lit when unit is plugged in. -
Page 10: Specifications
XCITE Field Test Power Supply Specifications Dimensions Height 33.5” Width 27.25” Depth 36.5” Weight 250 lbs Cooling Air (heat exchanger w/ fan) Maximum Ambient Air Temp 100° F Power Requirements 115 VAC, 35 Amp, 50/60 Hz, single-phase from Circuit Mains...