Windows Xp - elmeg T444 Manual

Windows XP

·
Open the Windows XP network connections.
Select the network adapter connected to the pabx by pressing the right mouse button. Then click »Status«.
·
The values shown in the screen shot are set as defaults for the initial settings of the PABX system. Depen-
ding on how many clients (PCs) are connected, the IP address lies within a range from 192. 168. 1. 50 to 192.
168. 1. 69. When these values are displayed, the network adapter and the Windows network settings have
been configured correctly. If other values are shown click the button »Repair«.
·
The value for the physical address is different for each network adapter. The values for the lease depend on
when the PC is switched on.
If other data continues to be shown this may be due to the following reasons:
·
Changes have already been made to the initial setting for the PABX system in the Professional Configura-
tor.
·
The Windows network configuration for the client (PCs) does not correspond to the factory settings De-
fault setting.
·
Faulty installation of the network adapter in the client (PC), or the network adapter is not connected pro-
perly with the PABX system. Check your installation as described in the operator's manual for the PABX
system (Installation and Commissioning section).
·
The TCP/IP protocol is not installed on the PC, or it has no link to the network adapter connected to the
PABX system.
Checking the TCP/IP Configuration
19