Filling With Fuel - GardenMaster GMPLMCNC Safety And Operating Manual

service life and using 2-stroke oil will damage the
engine.
Fig.E
Fig.F

5. FILLING WITH FUEL

WARNING! Petrol is highly inflammable and
extreme precaution must be taken when
handling or working with it. Keep out of reach of
children.
1) Clean the area around the petrol tank cap (17)
before removing the cap. Remove the warning label,
check the fuel level.
2) Refill the tank if the fuel level is low. Refuel
carefully to avoid overfilling or spilling fuel. There
should be no fuel in the tank neck.
3) Clean up any overflow or splash of petrol before
starting the engine.
4) Tighten the tank cap securely after filling.
Refuel in a well-ventilated area with the engine
stopped. Do not smoke or allow flames or sparks in
the area where the engine the engine is refueled or
where petrol is stored. Avoid repeated or prolonged
contact with skin or breathing of vapor.
NOTE: Petrol should be stores in an approved
container. Never buy or store more than 30 days
supply of petrol. Do not mix oil with petrol.
6. STARTING THE ENGINE (SEE FIG. G-I)
WARNING! Do not operate the machine in
a closed or poorly ventilated areas as the
exhaust gas contain poisonous substance. Keep
hands, feet, hair and clothing away from all the
moving parts of the machine. The exhaust and
other parts of the machine will become hot during
use. Make sure that the blade is securely fastened
before starting the engine.
NOTE: To start the engine, make sure that the spark
plug cap (9) is located on the spark plug and the
machine is filled with sufficient oil and petrol.
Step1: Throttle lever (2)-STARTING (See Fig. G)
For start a cold engine, move the throttle lever to the
CHOKE position.
For start a warm engine, move the throttle level to
the MIN position.
Fig.G
Step2: Pull starter handle (13) (See Fig. H1-H2)
With right hand, slowly but firmly pull the starter
handle and rope out until you felt resistance. Let the
rope recoil, then pull briskly. If the engine fails to
start after three pulls, repeat the start process. When
the engine starts, return the starter rope gently.
Fig.H1
Fig.H2
Step3: Throttle lever (2)-RUNNING
Once the engine is running, move the throttle level to
the position MIN (Fig. I).
Clear a flooded engine
If the engine won't start after you operated the
7