Page 1
Operating Instructions Petrol Brush Cutter " WARNING! PLEASE READ THESE INSTRUCTIONS BEFORE OPERATING THIS UNIT" "KEEP THIS MANUAL FOR FUTURE REFERENCE” SPJBC...
Page 2
Read and follow the operating instructions and safety information before using for the first time. Always wear PPE (Personal Protective Clothing). Wear eye protection! Wear ear protection! Helpline No: UK 0151 649 1500 / IRE 189 094 6244...
Page 3
Please read these instructions carefully before installing and operating the petrol brush cutter! Petrol Engine Quick Start Guide Ensure correct fuel/oil mixture 40:1 STARTING 1. Add the correct fuel mixture to unit. 2. Place the machine on a hard, level surface 3.
When using the equipment, a few safety Always keep in mind that the machine operator precautions must be observed to avoid injuries or user is responsible for accidents involving and damage. other persons and/or their property. Read the operating instructions carefully and Preliminary measures comply with them.
Page 11
5. Keep all screws and fasteners tight. Never Additional instructions operate your equipment when it is improperly adjusted or not completely and securely 1. DO NOT USE ANY OTHER FUEL than that assembled. recommended in your manual. Always follow 6. Keep handles dry, clean and free of fuel instructions in the Fuel and Lubrication section of mixture.
control if it comes up against objects which it C/23 Allen key (size 4) cannot cut through. This may result in C/24 Allen key (size 5) Serious injury. Keep onlookers and animals at C/25 2-stroke oil least 15 m away from where you are working. If the machine strikes a foreign body, stop the Safety devices When working with the blade the metal guard hood...
Important. Due to the high risk of bodily injury to the 6.4 Fitting / Replacing the line spool user, the petrol brush cutter must not be used to carry Line up the hole in the carrier plate with the notch out the following work: to clear dirt and debris off beneath it and lock the carrier plate with the size 6 walkways, or to chop up tree or hedge clippings.
Important: Do not use a fuel mixture which has been idle mode). kept for longer than 90 days. 8. If the engine does not start up, repeat steps 6-7 above. Important: Do not use 2-stroke oil with a recommended mixing ratio of 100:1. If inadequate Please note: If the engine does not start up even after several attempts, read the section lubrication causes engine damage, the...
MOWING Caution: Remove all grass and weed remains at For mowing you want to cut all the vegetation down to regular intervals to prevent the shaft tube overheating. the ground. To do this, set the cutting head at an Grass and weed remains become trapped under the angle of 30°...
with tension. The spool splitter will separate the The safety hood blade (Fig. F6/Item A) can become two halves of the nylon line (Fig. L5) blunt over time. When you notice this, undo the two 6. Hook the last 15 cm of the two ends of the line to screws holding the safety hood blade to the safety the line holders opposite the line spool (Fig.
damage. 12. Ordering replacement parts 1. Carry out all the maintenance work. 2. Drain the fuel out of the tank (use a conventional Please quote the following data when ordering plastic petrol pump from a DIY store for this replacement parts: purpose).
13. Troubleshooting Fault Possible cause Troubleshooting The machine does not start. Correct starting procedure not Follow the instructions for starting followed. or see page 19. Sooted or damp spark plug Clean the spark plug or replace it with a new one. Incorrect carburetor setting Contact an authorized customer service outlet.
Page 21
GUARANTEE CERTIFICATE Dear Customer, All of our products undergo strict quality checks to ensure that they reach you in perfect condition. In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card. Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below.
Page 24
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers accompanying products is permitted only with the express consent of ISC GmbH. Technical changes subject to change EH 10/2007...
Need help?
Do you have a question about the SPJBC and is the answer not in the manual?
Questions and answers