Main Volume / Record; Mix; Vibe-Watermark-Brig - MIXVIBES U-Mix DJ Set User Manual

5 Racks

5.2 Main Volume / Record

The screenshot above shows how the Main volume/Record rack looks with two soundcards
(i.e. two sets of controls). If you only have one soundcard installed then you will only see
one set of controls. With one soundcard, this rack only controls the master volume; with
volume1.pdf volume1.pdf
two soundcards this rack controls the master and the monitor volume.
1 Master: The master rack is a tool used to master your audio signal. It contains
the same settings found in the equalizer/mixer section of your media player but
concerns the master output. To avoid saturation, check the audio signal view.
If the signal is saturated you must change your settings in the Master volume
section or Equalizer/mixer section.
2 Preview: The preview rack is a tool used to preview your audio signal.
3 Recording: You can also record your mix in « .wav » format. Click the button
in the volume rack of your choice and designated the name and directory for
the recorded. The recording is active at once! Click again to stop the recording.
Keep an eye on the Record output view to make sure the recording does not
C
saturate!
M
J

5.3 Mix

CM
MJ
This tool enables you to control visually that the media files are in sync. Indeed the peaks
CJ
represent a sound increase and usually correspond to the beat of a track. When two
media files are in sync, the peaks are simultaneous. The player 2 peaks are displayed in
CMJ
the lower part in green, while the player 1 beats are displayed in red above.
N
02/04/2009 02/04/2009
1
2
15:25:26 15:25:26
Main Volume/Record
C
M
J
CM
MJ
CJ
CMJ
N
18 /
36
3

vibe-watermark-brig

vibe-watermark-brig