The unit interface boards. is designed to mount into a standard 2x4 draw-box. The MLM wall •The software version number is displayed while the software initi- controller is designed to work with Rickard PC based MLM software ates.
Page 3
3. Control mode: • PICTURE 3 indicates the diffuser is in heating mode and has reached the minimum stop position for heating. The neck heater is • After limits are detected, the controller will enter control mode. on as displayed. The diffuser could also be in heating mode without Room temperature is displayed.
Wall thermostat. If the Wall Thermostats setup menu is required and has been ena- bled on the MLM application or if you have purchased a setup mod- ule, the following display/setup options will be available (long press the menu button until the unit beeps and release to enter the setup menu on the wall thermostat).
SETUP OPTIONS 1. Supply Air Temperature Display (CO) • When a Supply Air (Change Over) sensor is fitted the supply air temperature will be displayed. • When no sensor is fitted, a zero value will be displayed. 4. Maximum Motor Limit Adjust (dr) •...
Page 6
• After a few seconds the Setup Module will beep and the flashing lection. The up/down arrows will toggle this function. LED on the MLM DC board will stay switched on momentarily this indicates the diffuser is set up for that control zone.
Page 7
8. Set Point Adjust The next function displayed is setpoint adjust with the ‘SP’ icon on. ♦ Note the setup module must be plugged into the control zone of interest for this function. ♦ The top left character display will indicate ‘S1’ for setpoint 1. Set- point 2, or the back off setpoint is not adjustable with this unit.