Telvue HyperCaster User Manual page 87

®
TelVue HyperCaster User Manual / v5.0 / October 2014
Manage Network Configurations
To manage your network configurations, click on the network option. The application displays
the Network Configuration Management screen.
Interface – the name of the host interface, such as eth0 or eth1.
•
Type – the type of network connection, such as Ethernet.
•
HW Address – Ethernet card identity
•
Link Detected – if the link is being detected.
•
IP Address – The IP address of the network. If the IP address is dynamic, this entry will
•
display DHCP. If DHCP is used, the assignment should match the MAC address of the Digital
Broadcaster.
Speed – the connection speed.
•
Route All Multicast On This Interface – if multicast is being streamed through that
•
ethernet port. To enable multicasting for this network connection, click on Route All
Multicast below the appropriate ethernet port. Multicast IP addresses must use the range
224.0.0.0 – 239.235.235.235.
Warning: Before enabling multicasting, talk to your system administrator.
Interface is Active – if the ethernet port is being used.
•
Using DHCP – if it is a DHCP or static IP Address.
•
Netmask– The Netmask value of the network. The default value is 255.255.255.0.
•
© 2014 TelVue Corporation
®
HyperCaster is a registered trademark of TelVue Corporation
16000 Horizon Way, Suite 500, Mt. Laurel, NJ 08054
800-885-8886 / www.telvue.com
86